PAGE 2 -- PRO-97 EDACS PROGRAMMING
PART D. PROGRAMMING TALKGROUP IDs
Talkgroup IDs are programmed in numerical order from lowest to highest. All analog talkgroup IDs have been programmed with
alpha tags so when moving into a new repeater area, you will only need to reprogram the frequencies in LCN order, rather than
reprogramming frequencies and talkgroup IDs with their associated alpha tags.
1. Press [PGM], [TRUNK]. The second line of the display shows EDACS TGID#xx.
2. Enter talkgroup IDs using the keypad. You can enter them using one, two, three, or four digits. I suggest entering them in
four digit blocks since the display defaults to four digits.
a. Example: Enter the HFD DISP talkgroup ID, 785. Press [0] [7] [8] [5] [ENTER]. The scanner accepts the
talkgroup.
b. Press the UP ARROW key. The display switches to EDACS TGID#xx. In this example, my display shows
TGID#01. Enter the next talkgroup, repeating steps a and b above.
PART E. PROGRAMMING TEXT-TAGS TO BANKS
NOTE: This mode works in both conventional and trunking mode.
1. Press [PGM].
2. Press [F] or [FUNC] followed by the bank number. To program Bank 0, press [F] + [0].
a. CAUTION: Pressing [F] + [CLR] deletes ALL frequencies.
b. Pressing [TEXT] edits the bank tag.
3. The cursor flashes on line 3. Enter the text using the keypad and press [ENTER] to accept.
PART F. PROGRAMMING TEXT-TAGS INTO MEMORY CHANNELS
Also, programming text-tags to talkgroup IDs, see #7.
1. Press [MANUAL], enter the channel number where you want to enter the text, then press [MANUAL] again. M and the
channel number appear in the upper left corner of the display. For example, M001.
2. Press [PGM]. The display changes from an M to a P, indicating programming mode.
3. Press [TEXT]. The cursor appears on the third line of the display.
4. Enter the text using the numeric keypad:
For example, input WAIKIKI-1 as follows:
W - Press 9 then 1
A - Press 2 then 1
I - Press 4 then 3
K - Press 5 then 2
I - Press 4 then 3
K - Press 5 then 2
I - Press 4 then 3
- - Press 0 then 2
1 - Press 1 then 1
5. Press [ENTER] to accept the text-tag.
6. In general, repeat all steps in this section to tag the other memory channels. That is, channels starting with Mxxx. Be
sure that the display shows "P", indicating programming mode.
7. To program text into Talkgroup IDs, press [PGM], [TRUNK], [TEXT]. The cursor on the 3rd line blinks, then follow step 4
above to program the actual text. (This will ONLY work if there is a talkgroup ID programmed). See Part D before
continuing with this step to program text tags to talkgroup IDs.
(20 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais