Radio-shack TAD 3809 Manual do Utilizador

Owner’s ManualPlease read before using this equipment.Digital Answering SystemTAD 3809

10PreparationCautions:You must use a Class 2 power source that sup-plies 9V AC and delivers at least 440 mA. Its plugmust fit the TAD's AC 9V 440

11Preparation1. Hold down SET until the TAD beeps. The TAD announces,“Sunday,” and 34343434 appears.Note: If necessary, slide VOLUME on the right side

12Preparationanswers a call. The maximum outgoing message length is 60seconds.Follow these steps to record the OGM.1. Hold down ANNOUNCE. The TAD beep

13PreparationSETTING THE NUMBER OF RINGSThe ring select switch (4/7/TS) controls how long the TAD waitsbefore it answers a call. Slide the switch to t

14OperationˆOperationRECORDING INCOMING MESSAGESThe TAD can record an incoming message of up to 180 sec-onds. If a recording reaches 175 seconds, the

15Operationthere are new messages, the display’s indicator flashes until allthe new messages have played.To play all the messages, press PLAY/STOP. To

16OperationPausing Message PlaybackTo pause while listening to messages, press PLAY/STOP. 3$3$3$3$ ap-pears. Wait at least 2 seconds, then press PLAY/

17OperationRECORDING A MEMOA memo is a message you can record on the TAD without hav-ing to call in on the phone. The maximum memo length is 60seconds

18Operation• listen to your messages• record a new announcement• delete messages• monitor the room where the TAD is locatedNote: You cannot remotely o

19OperationNotes: • Be sure to set each digit within 8 seconds of the last. Other-wise, the TAD exits setup and you must start again fromStep 1.• We r

2Read This Before InstallationˆRead This Before InstallationYour TAD is ETL listed to UL standards and meets all applica-ble FCC requirements.WARNING:

20OperationIf you have recorded an OGM, the TAD beeps andannounces, “Answer on.”Note: Pushing # again (once a message has beenrecorded) sets the TAD t

21OperationRemote CommandsAfter you press 4 or 5 to play messages, you can:Press To0Stop playback, recording, and room monitoring.1Play a new outgoing

22TroubleshootingˆTroubleshootingWe do not expect you to have any problems with your TAD Dig-ital Answering System, but if you do, the following sugge

23TroubleshootingCAREKeep the TAD dry; if it gets wet, wipe it dry immediately. Useand store the TAD only in normal temperature environments.Handle th

RadioShack CorporationFort Worth, Texas 7610243-380906A01Printed in ChinaLimited One-Year WarrantyThis product is warranted by RadioShack against manu

3Read This Before InstallationWe have designed your Telephone Answering Device (TAD) toconform to federal regulations, and you can connect it to mostt

4Read This Before InstallationTHE FCC WANTS YOU TO KNOWIn the unlikely event that your phone causes problems on thephone line, the phone company can t

5ContentsˆContentsFeatures ... 6Installation ...

6FeaturesˆFeaturesYour RadioShack Digital Answering System TAD 3809 storesall your messages on a computer chip — there are no tapemechanisms to wear o

7InstallationToll Saver — gives you time to hang up before the TAD an-swers to avoid charges when you call by long-distance to checkyour messages.Room

8InstallationINSTALLING THE BACKUP BATTERYThe TAD requires AC power to operate. If AC power fails, oryou unplug the TAD, a 9-volt battery (not supplie

9InstallationCONNECTING THE TADFollow these steps to connect your TAD to the telephone lineand phone.1. Unplug the telephone’s modular cord from its l